 |
Solutions for Time and Frequency Synchronization |
| Products | Support | Downloads | About Meinberg | Contact | Search |  |
| by Application | by Time Source | by Form Factor | Time Server | Product Archive | ||
 |
|
|
NTP Clock
 GPS170PCI slot card as time source for your network
GPS Slot Card
 The GPS180PEX can be installed in any single lane PCIe slot and offers an impressive selection of time, pulse and frequency outputs
GPS NTP
 LANTIME M300/GPS - Synchronization of NTP and SNTP compatible clients
NTP Time Server
 M600/GPS: High End NTP Time Server with integrated GPS radio clock. It synchronizes all systems either NTP- or SNTP-compatible and uses a built-in GPS radio clock as its reference time source
Timecode Converter
 The TCR167PCI receives IRIG-A/B or AFNOR time codes and can be used for synchronizing the system time of its host PC.
IRIG PCI
 The TCR511PCI is synchronized by modulated (DC Level Shift) and unmodulated (AM) IRIG and AFNOR time code signals and can be integrated in industrial systems that require high precision.
DCF77 Radio Clock - PCI/PCI-X Bus
 The PCI511 is a DCF77 radio clock for synchronization of computers with a PCI or PCI-X slot. It receives the longwave radio time signal from the DCF77 sender located near Frankfurt/Main, Germany. MEINBERG: Quality Management System
|
Key Features
|
|||||||||||||||||||||||||||||||||||||||||||||||
| Type of receiver: | 6 channel GPS C/A-code receiver |
| Type of antenna: | Remote powered GPS antenna/converter unit, up to 300m distance to antenna with RG58 and up to 700m distance with RG213 cable |
| Status info: | Fail-LED shows that the internal timing has not been synchronized or that a system error occurred Lock-LED shows that the calculation of the position has been achieved after reset |
| Synchronization time: | Max. 1 minute in normal operation mode, approx. 12 minutes after a cold start (discharged buffer battery) |
| Pulse outputs: | Pulse per second (PPS) and pulse per minute (PPM). TTL level, pulse width: 200msec |
| Accuracy of pulse outputs: | < ± 250ns |
| Interface: | Single serial RS232 interface |
| Data format PC interface: | IBM PC/XT/AT Bus Binary, byte serial (compatible with Meinberg DCF77 Slot Card PC32) |
| Data format of interfaces: | Baudrate: 300, 600, 1200, 2400, 4800, 9600, 19200 baud Framing: 7N2, 7E1, 7E2, 8E1, 8N1, 8N2 Output string: 32 ASCII characters with date, time and status information |
| Time-Trigger inputs: | Resolution: 100 nsec, triggered by falling TTL slope Time of trigger event readable via RS232-interface |
| Electrical connectors: | 9 pin sub D female connector BNC female connector |
| Power supply: | +5V, ca. 300mA +12V, ca. 200mA |
| Backup battery type: | When main power supply fails, hardware clock runs free on quartz basis, almanac data is stored in RAM Life time of lithium battery min. 10 years |
| Board type: | 8 bit short expansion board |
| Ambient temperature: | 0 ... 50°C / 32 ... 122°F |
| Humidity: | Max. 85% |
| Options: | Driver software for NetWare 3.1x/4x, Windows NT and OS/2 Additional RS232 interface Frequency output 10MHz |
Downloads
|
||
|
|
| [ Home | Products | Top ] |
|